![Recoup Logo HR_50mm (RGB).jpg]](https://knowledge.recoup.co.uk/hs-fs/hubfs/Recoup%20Logo%20HR_50mm%20(RGB).jpg?height=50&name=Recoup%20Logo%20HR_50mm%20(RGB).jpg)
Systems & Installation
General
- Can one Recoup WWHRS be connected to more than one Shower?
- Is it necessary to install an isolation valve on the pre-heat side of the WWHRS system?
- What is the maximum waste pipe length from the shower to the WWHRS unit?
- Do you install your WWHRS systems?
- Do you have installation guides?
- What are System A, B and C installation methods?
- Is there a Legionella risk?
- Is a normal shower waste (with a water trap) ok between the unit and shower tray? No HepVo trap or vent required?
- What type of shower will Recoup's WWHRS work with?
- Will WWHRS work with an electric shower?
- Do you need to pressure test a Recoup WWHRS?
- Can I tee a basin waste in to the shower waste on the way to the WWHR unit
- Do I need to use Pre-heat identification tape?
- What is the maximum length of pipework from the WWHRS to the hot water source? (Cylinder/Combi Boiler/Other)
- Where should valves be positioned?
- Can WWHRS be installed Outdoors or in a Garage?
- What does the WWHRS Utilisation Factor mean?
- Does Preheat Pipework need to be insulated?
- What are the testing requirements for the sanitary pipework?
- How to identify if WWHRS is installed in a property
Pipe HEX
- Are the Pipe HEX waste connections Push fit or Solvent weld?
- Does the Recoup Pipe HEX increase the boxing size around the SVP?
- Can the Recoup Pipe HEX be installed horizontally?
- Should I insulate the Recoup Pipe HEX within the SVP boxing?
- What fittings do I need to install the Pipe HEX?
- Does it matter which way up the Pipe HEX pipe goes?
- Can the Pipe HEX be used for Ground Floor showers?