WWHRS Knowledge Base

Back to home

WWHRS Knowledge Base

Systems & Installation

Systems & Installation

General

Can one Recoup WWHRS be connected to more than one Shower?

Is it necessary to install an isolation valve on the pre-heat side of the WWHRS system?

What is the maximum waste pipe length from the shower to the WWHRS unit?

Do you install your WWHRS systems?

Do you have installation guides?

What are System A, B and C installation methods?

Is there a Legionella risk?

Is a normal shower waste (with a water trap) ok between the unit and shower tray? No HepVo trap or vent required?

What type of shower will Recoup's WWHRS work with?

Will WWHRS work with an electric shower?

Do you need to pressure test a Recoup WWHRS?

Can I tee a basin waste in to the shower waste on the way to the WWHR unit

Do I need to use Pre-heat identification tape?

What is the maximum length of pipework from the WWHRS to the hot water source? (Cylinder/Combi Boiler/Other)

Where should valves be positioned?

Can WWHRS be installed Outdoors or in a Garage?

What does the WWHRS Utilisation Factor mean?

Does Preheat Pipework need to be insulated?

What are the testing requirements for the sanitary pipework?

See more

Pipe HEX

Are the Pipe HEX waste connections Push fit or Solvent weld?

Does the Recoup Pipe HEX increase the boxing size around the SVP?

Can the Recoup Pipe HEX be installed horizontally?

Should I insulate the Recoup Pipe HEX within the SVP boxing?

What fittings do I need to install the Pipe HEX?

Does it matter which way up the Pipe HEX pipe goes?

Can the Pipe HEX be used for Ground Floor showers?

See more

Easyfit+

Can I use flexible waste pipe from the waste outlet of the Easyfit+?

What clearance do I need under my bath to accommodate an Easyfit+ ?

Can I fit a Recoup Easyfit+ underneath a shower tray?

Can the Easyfit+ be fitted within a floor void?

Will the Easyfit+ fit under any bath?

See more

Drain+ Duo/HE/Compact

Can the Drain systems be used with a vinyl floor covering?